电源设计实例
- 文件大小:71.06KB
- 浏览次数:
- 发布时间:2012-03-30
本资料包含pdf文件1个,下载需要5积分
电源设计实例Design Highlights
Replaces a linear transformer based supply at the same or
lower cost but with much higher performance
<0.3 W consumption at zero load meets worldwide guidelines
(ECs 0.3 W, USAs 1 W for example)
Extremely simple circuit – only 15 components for production-
worthy design
Primary based CV/CC output – no secondary sense compo-
nents required
±10% output voltage and ±22% output current tolerances at
peak power point
Fully protected for thermal, short circuit and open loop faults
>62% effi ciency (>70% with R1 replaced by an inductor)
Meets CISPR22B/EN55022B EMI limits with low cost resistive
•
•
•
•
•
•
•
•
the transformer (formed from part of the primary) the design meets
conducted EMI limits with no Y-capacitor between primary and
secondary. Resistor RF1 also functions as a fuse.
LinkSwitch derives all feedback information from the primary.
During output diode conduction, the output voltage transformed
through the turns ratio is sampled and held by C4. The feedback
voltage across C4 (VOR) is converted into feedback current by R2
and fed into the CONTROL pin. This feedback current regulates
the output by PWM control during CV operation, and by reducing
the internal current limit during CC operation. Below an output
voltage of 2 V, LinkSwitch enters auto-restart, limiting average
output current to <50 mA. The nominal transition from CV to CC
occurs at 5.5 V, 0.27 A. The output envelope characteristic and
- 1YD 5066-1998 光缆线路自动监测系统工程设计暂行规定
- 2砖混住宅楼施工组织设计
- 3某装修平面设计布置cad图纸
- 4工程费用索赔的构成内容
- 5钢转钢梯图纸
- 6建设工程检测见证取样员培训PPT课件(建材部分)
- 71:500 1:1000 1:2000 外业数字测图技术规程
- 8轻型货车CAD图纸
- 9solidworks 木制儿童玩具设计SolidWorks设计
- 10改性沥青混凝土的施工控制和监理要点
- 11一级建造师执业资格考试市政实务问答题点浓缩
- 12市政公用工程设计资格分级标准
- 13一个CFG桩基工程施工组织设计
- 14NY/T 3060.3-2016 大麦品种抗病性鉴定技术规程 第3部分:抗赤霉病
- 15单位工程施工组织(盛业豪园二期)