滚子摆动从动件盘形凸轮的设计及优化
- 文件大小:268.08KB
- 浏览次数:
- 发布时间:2014-03-15
本资料包含pdf文件1个,下载需要1积分
The design of oscillating roller follower cam and integrated optimization of contact stress and body size were researched for an optical system. Based on design requirements, analytical method gave profile curve of cam through Matlab. Stress analysis was done on the basis of Hertz formula, and established mathematical model of optimization of contact stress and body size. By optimization contact stress declines from 198 MPa to 176 MPa (11%), and body size declines 50%. The optimization makes cam better meeting the application requirements and miniaturiza- tlon requirements.针对某光学系统要求,对滚子摆动从动件盘形凸轮的设计和凸轮滚子间接触应力与机构体积的综合优化方法进行了研究.根据设计要求,通过Matlab软件,用解析法获得凸轮理论廓形曲线,采用赫兹公式对得到的凸轮曲线进行接触应力分析,建立接触应力和机构体积综合优化的数学模型,通过优化使得最大接触应力由198MPa降至176MPa,下降了ll%,同时机构体积下降了50%,使机构更好地满足了使用要求和小型化的要求.
- 1R2145回转窑挡轮总成
- 2《高速公路冬季养护初探》
- 3主要分项工程质量通病及防治措施正文
- 44.1综合布线系统
- 5桥架重量计算
- 6新东风小区别墅装修设计施工图
- 7GB/T 33291-2016 氢化物可逆吸放氢压力-组成-等温线(P-C-T)测试方法
- 8JIS Z8221-1-2006 设备用图形符号的基本原则.第1部分:原始符号的制定
- 9深井泵电机爆炸图
- 10水泥混凝土面层施工工艺标准
- 11GB/T 6391-2003 滚动轴承 额定动载荷和额定寿命
- 12御龙湾商业街建筑设计施工图纸带效果图
- 13L2.6/10螺杆式空压机的设计及改进
- 14自行车V刹SolidWorks设计
- 15总图设计(教材)