基于真实粗糙齿面的弹流润滑效应分析
- 文件大小:560.57KB
- 浏览次数:
- 发布时间:2014-03-07
本资料包含pdf文件1个,下载需要1积分
The approximate tooth surface roughness equation was set up by using Fourier nonlinear approximation meth od based on the actually measured roughness. Under the constant unit tooth width load, the influences on oil film thickness and gearing contact stress were analyzed by Muhigrid method, when changing any one value of the lubricant viscosity and the teeth surface entrainment velocity simultaneously and fixing their product. The resuhs show that, under full film lubri cation, it has no influence on oil film thickness and gearing contact stress to change any one value of the lubricant viscosity and the teeth surface entrainment velocity simultaneously in the above conditions. However under mixed lubrication, the average film thickness is increased and gearing contact stress is decreased along with the increasing of the lubricant viscosi ty.基于真实测量的齿面粗糙度数值,利用傅里叶非线性回归原理,生成近似真实齿面粗糙度曲线方程。在固定单位齿宽载荷的情况下,采用多重网格法分析润滑油黏度和齿面综合速度之乘积固定不变而同时改变其中任一量时,对油膜厚度以及轮齿接触应力的影响,得出油膜平均厚度以及齿轮次表面剪应力的相应数值解。计算结果表明:在全膜润滑中,在上述条件下同时改变黏度和齿面综合速度其中任一量对油膜厚度以及轮齿接触应力影响不大;而在混合润滑中,随着黏度的增大,平均油膜厚度增加,齿面接触应力减小。
- 1YD/T 2618.1-2013 40Gb/s相位调制 光收发合一模块技术条件 第1部分:差分相移键控(DPSK)调制
- 2屋面防水质量保证措施
- 3中央空调选型、设计施工与维修保养手册
- 4某大桥挖孔桩施工方案
- 5窗帘盒大样设计cad图纸
- 6哈大线施工组织设计方案
- 7建筑工程造价管理
- 8YD/T 1610-2007 IPv6路由协议测试方法—支持IPv6的中间系统到中间系统路由交换协议(IS-IS)
- 9广场电气施工总结
- 10钢结构施工测量方法介绍
- 1120国道改造工程监理规划
- 12泄压管图纸
- 13机械回填土技术交底
- 14SJ/T 10247.8-1992 音频电力负荷控制系统 可靠性试验方法
- 15招投标合同